CARTER STEEL GUITARS'
OWNERS' ONLINE SUPPORT

Carter Pedal Kit Installation Instructions

I. INTRODUCTION and Slide Show Index:

Please remember to:

(1) Have the following tools and items available:

• Carter Pedal Kit:

Pedal Cross-Shaft Pull Bars Pull Rods Tuning Nuts Pull Pins Nylon Washers

6-32 Buttonhead Torx Screws Delrin Pedal Rod Hex Set Screw Pedal Brackets 6-32 Flathead Screws Numbered Pedal Rod Clear Grease

• Phillips Screwdriver
• Flat-Blade Screwdriver
• Carter Wrench Kit
• Hammer
• Towel
• Table or Workbench
• Small block of wood (about 1"x2"x4" or 2.5cm x 5cm x 10cm)
• Carter Owner's Manual
• (optional but very helpful:) Small Pair of Long-Nose Pliers
• (optional but helpful:) Wrench

(2) Refer to the drawings in your Carter Owner's Manual and to the Factory Rodding Chart.